Power switch button
1. Click Turn on, and the device turns on
2. Click Close to shut down the device
3. Click power during operation to enter standby mode, and shut down after 1 minute without operation
There are 2 drying modes.
The user clicks the "Drying" button on the device side, the default is to enter "Short Hair Drying", click to switch to "Long Hair Drying", then click to switch to "Short Hair Drying", and so on. Drying for long hair is 90 minutes (tentative), and drying for short hair is 60 minutes (tentative). The default drying time depends on the test results.
The drying temperature depends on the test results
When drying begins, the lighting lamp is turned on immediately, and when the drying is over, the lighting lamp is turned off immediately
PTC heater
1. After starting to dry for 5 seconds, the PTC heater is turned on and slowly heats up, and then the temperature in the box must be kept at 38.5°C. The fan will start running 15 seconds after the PTC is turned on.
2. 2 minutes before the end of the operation, the PTC stops heating, and the negative ions are released for 2 minutes after the mode is turned on, and then released once every 10 minutes, once for 2 minutes.
Buzzer
1. There is a short tone when you click the button
2. When the drying is over, the buzzer will emit 10 consecutive "dididi" to notify the user of the end of the drying.
Fan
1. After the drying starts, the fan will start running 15s after the PTC is turned on, and the wind speed will gradually increase to 2 gears within 10 seconds.
2. 1 minute before the end of the drying countdown, the fan stops running
Ozone physical button
1. Long press for 5 seconds to turn on the ozone mode, click the power button to exit
2. Before the ozone operation, make sure that there are no living things in the cabin
3. The longest time of ozone operation is 20min
4. When the ozone is running, the operating wind speed and drying are invalid
Note: Hygienic standard for ozone in indoor air GB/T 18202-2000. This standard is expressed in terms of time concentration. The average maximum allowable concentration in 1 hour is 0.1mg/m³. The default disinfection time depends on the test results.
Wind speed physical button
1. There are 3 levels of wind speed, after turning on the drying, it will gradually increase to level 2 within 10 seconds and remain unchanged
3. The default is 2 gears, click to adjust the wind speed gears, rotate to the right to increase by 1 gear, and to the left to decrease by 1 gear, every time there is a sense of pause.
How to set the time.
1. Rotate the time knob to the left, and perform subtraction based on the current time (multiple of 5)
2. Rotate the time knob to the right, and add on the basis of the current time (multiple of 5)
Care solution
The care solution will be sprayed once 5 minutes after the beginning of the drying and 10 minutes before the end, 2 times in total, 15s each time. The time is to be determined for 15s. Follow-up adjustments will be made according to the test.
Pet requirements
Suitable for cats and small dogs, of which cats support under 9kg, and dogs support under 9kg.
The care solution will be sprayed once 5 minutes after the beginning of drying and 10 minutes before the end, 2 times in total, each 15s can be used according to the test results; the release time depends on the test results.